How to incorporate pulsations, slug loads, blast loads, water hammer/surge, and relief valve opening effects into your stress analysis? By learning how to use the dynamic module within CAESAR II, you can proficiently conduct such analyses.
Leveraging the full potential of CAESAR II’s dynamic module provides engineers with a more precise assessment of system stresses in comparison to quasi-steady studies. This enhanced accuracy can potentially reduce the required number of modifications and uncover unforeseen failures.
CAESAR II’s dynamic module offers various solvers, including Modal, Time History, Harmonic, and Spectrum Analyses. The selection of the solver and parameters depends on the specific load case under analysis.
DRG/Hexagon PPM
This training is organized in cooperation with Hexagon PPM. The training will be presented by DRG at the DRG office, but the administration process will be handled by Hexagon PPM.
Prerequisites and level
Intended For
This course is designed for:This is a classroom based course provided on behalf of and in cooperation with Hexagon PPM
Participants of this course receive a personal physical certificate from Hexagon PPM upon the completion of the course.
After this course, participants can expect to:
Training Courses Performing Vibration Measurements: Pipe Stress Assessment Download Brochure About The Course This course teaches you all the fundamentals required for performing vibration measurements
Training Courses Piping: Structural Integrity About The Course Enhance your expertise in addressing technical challenges on a petrochemical plant. Join our introductory level ‘Piping Structural
Training Courses Pipe Stress Analysis About The Course Pipe stress engineering is a broad area of expertise. To perform a pipe stress analysis you’re required
Laan van Oversteen 20
6th floor
2289 CX Rijswijk
The Netherlands
© Dynaflow Research Group BV
